Drag Down Grading?

Discuss with people in the know your tackle related questions

Moderator: John Softly

Post Reply
Posts: 63
Joined: Tue Dec 05, 2006 9:39 pm
Location: sunshine coast

Drag Down Grading?

Post by mickel » Sat Jul 21, 2012 6:30 pm

Does anybody have any ideas on how to down grade a drag??
IE:from say 10kgs to 4-5kgs,I am talking shimano 2500 size or can you get hold of
spools with lighter drags to suit???


Posts: 4
Joined: Thu Nov 01, 2012 11:05 am

Re: Drag Down Grading?

Post by RossG » Wed Nov 14, 2012 12:25 pm

I am aware of a spacer you can get for that sized daiwas that essentially makes the drag in the spool act as if it was a shallow spool. IIRC it is a small brass dish like piece that takes the place of 2of the 3 drag washers and allows you to run a single washer.

Bear in mind though that this will only change you maximum drag setting not the increments by which your drag is adjusted. If that makes sense.

Posts: 18
Joined: Wed Jun 26, 2013 2:15 pm

Re: Drag Down Grading?

Post by toygtr » Sun Dec 29, 2013 9:50 am

If you run carbon drags it will allow you to run finer drag pressure as they run smoother. You could also apply more grease to the washers allowing more slip on them but i personally wouldnt do that on the off chance you need to lock it up a bit more because of some structure.

Posts: 140
Joined: Wed Apr 09, 2003 11:35 am
Location: Brisbane

Re: Drag Down Grading?

Post by rayman » Mon Dec 30, 2013 6:05 pm

Perhaps drag washers with a oversized inner bore or undersized outer diameter.
As suggested, extra grease should also work.
Raymond Y

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests