LAMIGLAS RODS

[rockystar]

any info on the lamiglas rods flats elite , finess elite & racks elite
pro's con's aftersales service , warrenty, breakages ect . any info please

[fishconnect]

Rocky,
You can see some of the lamiglas rods in action in the fishconnect TV section of http://www.fishconnect.com.au There is also lots of info on these rods if you have a look around the site.

Jay

http://www.fishconnect.com.au

[rockystar]

Rocky,
You can see some of the lamiglas rods in action in the fishconnect TV section of http://www.fishconnect.com.au There is also lots of info on these rods if you have a look around the site.

Jay

http://www.fishconnect.com.au

cheers jay , have u used them 4 long , is it just the finess elite u r using ?couldn't find the info on the site ?

[H Wood]

Rocky,
Check out blueacres.com.au

H.

[rockystar]

Rocky,
Check out blueacres.com.au

H.

thnx mate , i would like some input off unbiast ppl who have been using these rods and what they think, good or bad ...

[H Wood]

Mate, i fish with all three of the elite series, cant rate them highly enough.

H.

[Bream Fisho]

How much do these rods retail for?

[rockystar]

How much do these rods retail for?

from what i've seen roughly $550 to $600

[Smokindrags]

Great rods
i have only used one once
felt a little strange at first but was really nice

[Boris]

had a lamiglass
very nice rod but really different from any other rod available.
the xmg50 grips are amazing and the rods fit in your hand realy nicely and are incredibly light ans sensitive.
however the blanks are fairly fragile due to the wrapping technique used but if you look after them they won't let you down.

If you don't have your heart set on an "elite" jim hickson from taree has a few xmg50s for 350 each
which is almost half thier RRP otherwise the XMG range retails for around 550 and the one with the cork grips retails for
around the 350 mark

hope this helps
Boris

[rockystar]

thanks 4 all the hints and info guys , i have brought the flats elite and not long after brought the finess elite .
very nice rods indeed ... i did have a breakage on the flats elite whilst casting . it was replaced without too much drama .i also have a mate which uses a heavier xmg 4 snapper & loves it, only downfall is the stripper guide is a bit small .once again thank u all .